Circutek PD-776
Pre-dip solution used in conjunction with CIRCUTEK C-777activator in catalyzing the substrate for subsequent electroless copper deposition. CIRCUTEK PD-776replaces the hydrochloric acid and water normally used in the step prior to the activator and in the activator solution itself.
Download Data Sheets
Related products
-
CuBrite™ PC-525
A copper plating additive for acid sulfate plating baths designed specifically for high throwing power through-hole plating of printed circuit boards. CuBrite PC-525 produces bright copper deposits that provide consistent thermal stress performance. CuBrite PC-525 is a single, clear addition agent, added on an ampere hour basis, which is used to control the brightness and physical properties of the deposit. The extreme stability of this additive greatly reduces the need for routine solution purification.
-
Cupric Etching Equipment Cleaner
Provides an effective clean out of Cupric Etcher sumps along with manual removal of deposits on the etch chamber walls. CUPRIC ETCH EQUIPMENT CLEANER will dissolve Dry Film deposits built up between PM’s. CUPRIC ETCH EQUIPMENT CLEANER has a low VOC content for reduced air emissions.
-
Layer Clean™ CR
An acid, non-etching cleaner that provides the most effective removal of chromate conversion coating from copper laminate. LAYER CLEAN CR also removes soils such as fingerprints and oxides. Used prior to photoresist lamination, it reduces imaging defects by improving photoresist adhesion. LAYER CLEAN CR’s non-chelating, non-chloride formula cleans and conditions copper surfaces, and provides consistent high speed cleaning at low concentrations. It is effective in both spray and soak applications.
