Circutek C-777
Low acid activator system used to catalyze non-metallic surfaces for the subsequent metallization by electroless copper. CIRCUTEK C-777is primarily used in the fabrication of printed circuit boards but can also be used in any application where the metallization of a non-conductor is desired.A pre-dip solution is necessary to pre condition the substrate and to minimize drag-in of water into the CIRCUTEK C-777. Make up the pre-dip solution according to instructions below, or use CIRCUITEK PD-776 liquid.CIRCUTEK PD-776Sis also used in the preparation of CIRCUTEK C-777.
Download Data Sheets
Related products
-
Layer Clean™ NP
An acid, non-etching cleaner that provides the most effective removal of chromate conversion coating from copper laminate. LAYER CLEAN NP also removes soils such as fingerprints and oxides. Used prior to photoresist lamination, it reduces imaging defects by improving photoresist adhesion. LAYER CLEAN NP’s non-chelating, non-chloride, phosphate free formula cleans and conditions copper surfaces, and provides consistent high speed cleaning at low concentrations. It is effective in both spray and soak applications.
-
DX™ Strip BAT
Provides additional antitarnish protection while removing fully aqueous liquid photoresists in spray or soak applications. DX STRIP BAT is also effective on aqueous dry film photoresists, and on a combination of liquid and dry film resists being stripped in the same process. It will generally break dry films into particles suitable for filtration. DX STRIP BAT has a low VOC content for reduced air emissions.
-
DPC-20 Screen Cleaner™
A safe solvent based material for the removal of uncured printing inks and solder masks. It contains no chlorinated hydrocarbons and no flammable solvents. DPC-20 SCREEN CLEANER is fast acting and has high holding capacity for economy and higher productivity.
